Pump, Water: Installation: 6.4L

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Water Pump Removal & Installation Sequence

Courtesy of CHRYSLER GROUP, LLC

Clean mating surfaces and install water pump. Tighten mounting bolts in sequence to Specifications. Refer to SPECIFICATIONS .
Install belt tensioner assembly (14). Refer to TENSIONER, BELT, INSTALLATION .

Fig 2: Lower Radiator Hose
Courtesy of CHRYSLER GROUP, LLC
Install the lower radiator hose (5).
Install the lower bypass hose (3).

Fig 3: Supply Line Bracket Nut, Temperature Sensor Electrical Connector & Supply Line
Courtesy of CHRYSLER GROUP, LLC
Install the supply line bracket (1).
Connect the temperature sensor electrical connector (2).
Install the supply line (3).

Fig 4: Bolt, EGR Cooler Hose & Bypass Tube
Courtesy of CHRYSLER GROUP, LLC
Install upper bypass tube (3).
Install the EGR cooler hose (2).

Fig 5: Upper Radiator Hose
Courtesy of CHRYSLER GROUP, LLC
Install the upper radiator hose (4) to the thermostat housing (1).
Install cooling fan assembly. Refer to FAN, COOLING, ELECTRIC, INSTALLATION FAN, COOLING, VISCOUS, INSTALLATION .
Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
If removed, install the secondary generator. Refer to GENERATOR, INSTALLATION .

Fig 6: Intake Manifold Removal/Installation Sequence
Courtesy of CHRYSLER GROUP, LLC
Install the Intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION, 6.4L .
Connect negative battery cable.
Check cooling system for leaks. Refer to DIAGNOSIS AND TESTING .