6.7L Diesel
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Clean and inspect the threads in the cylinder block and heater element.
- Coat the heater element threads with Mopar® Thread Sealer with Teflon.
- Screw the engine block heater (1) into the engine block and tighten to 75 N.m (55 ft. lbs.).
- Connect the block heater cord and securely tighten retaining cap (1).
- Fill the cooling system with recommended coolant. Refer to STANDARD PROCEDURE .
- Connect both of the negative battery cables.
- Start and warm the engine.
- Check the engine block heater for leaks.