6.7L Diesel Engine
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - IDLER PULLEY |
| 2 - ACCESSORY DRIVE BELT |
| 3 - P/S PULLEY |
| 4 - RADIATOR FAN PULLEY |
| 5 - CRANKSHAFT PULLEY |
| 6 - ACCESSORY DRIVE BELT TENSIONER |
| 7 - GENERATOR |
| 8 - WATER PUMP |
| 1 - IDLER PULLEY |
| 2 - ACCESSORY DRIVE BELT |
| 3 - P/S PULLEY |
| 4 - RADIATOR FAN PULLEY |
| 5 - CRANKSHAFT PULLEY |
| 6 - A/C COMPRESSOR PULLEY |
| 7 - ACCESSORY DRIVE BELT TENSIONER |
| 8 - GENERATOR |
| 9 - WATER PUMP PULLEY |
| 1 - GENERATOR |
| 2 - WATER PUMP |
| 3 - IDLER PULLEY |
| 4 - RADIATOR FAN PULLEY |
| 5 - GENERATOR |
| 6 - P/S PULLEY |
| 7 - CRANKSHAFT PULLEY |
| 8 - A/C COMPRESSOR PULLEY |
| 9 - ACCESSORY DRIVE BELT TENSIONER |
| 10 - ACCESSORY DRIVE BELT |
- Disconnect and isolate both of the negative battery cables.
- Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL, 6.7L .
- A 1/2 inch square hole is provided in the automatic belt tensioner (6). Attach a suitable tool into this hole.
- Rotate tensioner assembly clockwise (as viewed from front) until tension has been relieved from belt.
- Remove belt from water pump pulley first.
- Remove belt from engine.