LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 883 (Heating & Air Conditioning (Service Information) 2500 Hd & 3500 Hd) >> Plumbing >> Line, A/C Discharge >> Removal >> 3.6L, 5.7L Engine

3.6L, 5.7L Engine

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

Fig 1: A/C Discharge & Liquid Lines
GC0089589Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the nut (2) that secures the A/C discharge line (3) to the condenser jumper line tapping block (1).
  4. Disconnect the A/C discharge line from the condenser jumper line tapping block.
    Fig 2: Accessory Drive Belt
    GC0089585Courtesy of CHRYSLER GROUP, LLC
  5. Remove the nut (2) that secures the A/C discharge line (3) to the A/C compressor (4).
  6. Disconnect the A/C discharge line from the A/C compressor.
  7. Disconnect the wire harness connector from the A/C pressure transducer.
  8. Remove the plastic retaining brackets that secure the A/C discharge line to the A/C suction line and to the upper front of the engine.
  9. Remove the A/C discharge line from the engine compartment.
  10. Remove and discard the O-ring seals and gaskets from the A/C discharge line and install plugs in, or tape over the opened discharge line fittings and the jumper line and compressor ports.
  11. If necessary, remove the A/C pressure transducer from the A/C discharge line. Refer to TRANSDUCER, A/C PRESSURE, REMOVAL .
scientia non olet · About LEMON Manuals