Coil Spring

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All torques should be made with the full vehicle weight on the ground being supported by the tires.

Fig 1: Spring & Isolator

Courtesy of CHRYSLER GROUP, LLC

Position spring (1) and isolator on the axle and align into the spring upper pocket.
Carefully raise the rear axle into place.

Fig 2: Shock Lower Bolt & Nut
Courtesy of CHRYSLER GROUP, LLC
Install the shock lower bolt and nut (2), and do not tighten.
Remove the holding fixture for the rear axle.
Remove the support and lower the vehicle.
Tighten shock lower bolt and nut to specifications. Refer to SPECIFICATIONS .