LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 878 (Propeller Shaft - 2500 Hd & 3500 Hd) >> Bearing, Drive Shaft Center, Heavy Duty >> Removal >> Removal >> 2500 And 3500

2500 And 3500

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Marking Reference Marks On Rear & Front Shaft
GC0107569Courtesy of CHRYSLER GROUP, LLC
  1. Remove rear propeller shaft.
  2. Make installation reference marks on rear shaft (1) and front shaft (2).
    Fig 2: Slip Joint Boot And Clamp
    GC0107570Courtesy of CHRYSLER GROUP, LLC
  3. Remove slip joint boot (1) clamp (2).
    Fig 3: Boot And Collar
    GC0107571Courtesy of CHRYSLER GROUP, LLC
  4. Slide boot (1) off boot collar (2) and separate the two shafts.
    Fig 4: Removing Center Bearing
    GC0107572Courtesy of CHRYSLER GROUP, LLC
  5. Position Bearing Splitter Tool (special tool #1130, Splitter, Bearing/Gear) (1) between propeller shaft and center bearing (2).
  6. Install Bridge (special tool #938, Bridge) (3) on the splitter (1) and remove center bearing.
scientia non olet · About LEMON Manuals