LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 877 (6.7L Engine (Service Information) 2500 Hd & 3500 Hd) >> Engine Mounting >> Insulator, Engine Mount, Front >> Removal >> Left Side

Left Side

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Cover, Bolts & Oil Dipstick
GC0161582Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate both of the both negative battery cables.
  2. Remove the engine oil dipstick (2).
  3. Remove bolts (1) and the engine cover (3).
  4. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL, 6.7L .
  5. Remove the left front tire and wheel assembly.
  6. Remove the left front wheel house splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
  7. If equipped, remove the left side generator and bracket. Refer to GENERATOR, REMOVAL .
    Fig 2: Engine Lifting Bracket & Bolts
    GC0168121Courtesy of CHRYSLER GROUP, LLC
  8. Install the Engine Lifting Bracket (1) (special tool #10474, Brackets, Engine Lifting) and securely tighten bolts (2).
  9. Install Engine Support Fixture tool (special tool #8534B, Fixture, Driveline Support).
  10. Raise and support the vehicle.
    Fig 3: Frame Mounts
    GC0137135Courtesy of CHRYSLER GROUP, LLC
  11. Loosen the right side a thru-bolt and nut (1).
  12. Remove support and lower the vehicle.
  13. Lift the engine SLIGHTLY  and remove the left side thru-bolt and nut (1).
  14. Partially raise and support the vehicle.
    Fig 4: Identifying Drain Valve, Drain Hose, Mounting Screws, Sensor Harness Connector & Filter Housing
    GC0137154Courtesy of CHRYSLER GROUP, LLC
  15. Remove the fuel filter/water separator housing drain hose (6).
    Fig 5: LH Engine Mount
    GC0137137Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    4X4 engine mount shown in illustration 4X2 similar.

    NOTE:

    Left engine mount is removed from the bottom.

  16. Going through the wheel well, remove bolts (1) and the left engine mount (2).
scientia non olet · About LEMON Manuals