LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 877 (6.7L Engine (Service Information) 2500 Hd & 3500 Hd) >> Air Intake System >> Body, Air Cleaner >> Removal >> Removal

Body, Air Cleaner: Removal: Removal

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Intake Air Housing Bolt
GC0155101Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate both of the negative battery cables.
  2. Remove the intake air housing bolt (2).
    Fig 2: Identifying MAF Sensor, TBAP Sensor, Intake Air Tube, Air Cleaner Body & Clamp
    GC0137134Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the Mass Air Flow (MAF) sensor wire harness connector (3).
  4. Disconnect the TBAP sensor wire harness connector (2).
  5. Loosen clamp (4) and disconnect the intake air tube (5) from the air cleaner body (1).
  6. Lift up and remove air cleaner body (1).
    Fig 3: Ram Air Actuator & Wire Harness Connector
    GC0155333Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the ram air actuator wire harness connector (1).
scientia non olet · About LEMON Manuals