LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (6.4L Engine (Service Information) - 2500 Hd & 3500 Hd) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal >> Right

Cover(S), Cylinder Head: Removal: Right

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Battery Cables & Components
GC0155269Courtesy of CHRYSLER GROUP, LLC
  1. Remove nut (1) and the negative battery cables (10, 11).
  2. Remove the engine cover.
  3. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL  .
    Fig 2: Fuel Injector Electrical Connectors
    GC0161579Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the ignition coil harness connectors (2).
  5. Disconnect the fuel injector harness connectors (1).
  6. Position the engine harness aside.
  7. Remove the coolant lines from the cylinder head cover and position aside.
    Fig 3: Removing/Installing Ignition Coil
    GC0080076Courtesy of CHRYSLER GROUP, LLC
  8. Remove the ignition coil retaining bolts.
  9. Remove the ignition coils (1).
    Fig 4: Cylinder Head Cover Removal/Tightening Sequence
    GC0080292Courtesy of CHRYSLER GROUP, LLC
  10. Using the sequence shown in illustration, remove the cylinder head cover retaining bolts.
    Fig 5: Cylinder Head & Cover
    GC0139403Courtesy of CHRYSLER GROUP, LLC
  11. Remove the cylinder head cover (1).
  12. Clean the sealing surface of the cylinder head (2).
NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.

scientia non olet · About LEMON Manuals