Theory Of Operation

The internal Watchdog is a separate hardware circuit that continuously monitors the microprocessor. To insure the proper operation of the transmission controller the watchdog must receive a signal from the microprocessor within a specific time window (14 msec ± 1 msec) to prevent a system shutdown after a short delay (570 msec). The microprocessor periodically tests the watchdogs ability to provide this shutdown function using a three phase test;

• Send the signal too late > 15 msec
• Send the signal too early < 13 msec
• Delay test < 590 msec

If the watchdog input signal arrives too early or too late, the Watchdog Fault line will go low and the watchdog delay will start to time out. The delay will reset by the correct timing of the watchdog signal sent during subsequent operations.

The Delay Test checks the delay time out. The Delay Monitor line is pulled low, which forces the delay to start timing out. At the end of the delay time the Transmission Relay will turn off. The delay test, upon detection of the relay turning off, will immediately turn the relay back on before shutdown can occur.