Diagnostic Test

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
1. With the scan tool, read Electronic Shift Module (ESM) DTCs and record on the repair order.
2. Record the Event Data and Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Event and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read ESM DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Go To 3
CHECK FOR TRANSMISSION CONTROL MODULE (TCM) DTCS
1. With the scan tool, read TCM DTCs and record on the repair order.
  Are any TCM DTCs set?
  
  Yes
  - Repair TCM DTCs. Refer to appropriate Electrical Diagnostics article.
  - Perform the ESM VERIFICATION TEST. Refer to ELECTRONIC SHIFT MODULE (ESM) VERIFICATION TEST .
  No
  - Using the schematics as a guide, check the Transmission Control Module (TCM) connector and all related in-line connector terminals for corrosion, damage, or pushed out terminals. Pay particular attention to the power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information. Refer to VALVE BODY, REMOVAL .
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
CHECK WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle the wires while checking for shorted and open circuits.
4. Check for any Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ESM VERIFICATION TEST. Refer to ELECTRONIC SHIFT MODULE (ESM) VERIFICATION TEST .
  No
  - Test complete.