LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Body - Interior & Exterior) >> Seats >> Cover, Seat Cushion, Rear >> Removal >> Removal

Cover, Seat Cushion, Rear: Removal: Removal

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: J-Straps
GC0085491Courtesy of CHRYSLER LLC
NOTE:

It is not necessary to remove the rear seat assembly in order to remove the seat cushion foam and cover.

  1. Place the cushion into the up position.
  2. Disconnect the seat cushion heat mat electrical connector, if equipped.
  3. Release the J-straps (2) and remove the foam/cover (1) from the seat cushion frame.
    Fig 2: Seat Back Hog Rings
    GC0084645Courtesy of CHRYSLER LLC
  4. Roll the cover (3) off of the foam (1) and remove the hog rings (2).
  5. Separate the cover from the foam.
  6. Remove the seat cushion frame bolts and remove the seat cushion frame. Refer to DESCRIPTION .
scientia non olet · About LEMON Manuals