Clutch B Assembly

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

1. Wave plate

2. Steel plate

3. Backing plate

4. Friction plate

NOTE:

If clutch discs are being replaced, soak in 8HP trans fluid before assembly.

Position the input/output and the P4 annulus drum assembly on (special tool #8925-3, Assembly, Press Fixture) and (special tool #1130, Splitter, Bearing/Gear).

Fig 1: Press Fixture
Courtesy of CHRYSLER GROUP, LLC

Fig 2: Splitter, Bearing/Gear
Courtesy of CHRYSLER GROUP, LLC

Fig 3: Backing Plate & Annulus Assembly
Courtesy of CHRYSLER GROUP, LLC
Install the backing plate (1) onto the input/output shaft.

Fig 4: Friction & Steel Plates
Courtesy of CHRYSLER GROUP, LLC
Install the friction and steel plates (2).

Fig 5: Annulus Assembly & B-Clutch Wave Plate
Courtesy of CHRYSLER GROUP, LLC
Install the B-clutch wave plate (1).

Fig 6: Annulus Assembly & Gear
Courtesy of CHRYSLER GROUP, LLC
Install the P1 annulus onto the input/output shaft (1).

Fig 7: Annulus Assembly & Shim
Courtesy of CHRYSLER GROUP, LLC
Install the correct selectable shim (1) onto the P1 annulus.

Fig 8: Wave, Steel, Backing & Friction Plates

Courtesy of CHRYSLER GROUP, LLC