LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Electronic Control Modules (Service Information) - 1500) >> Module, Powertrain Control >> Removal >> Diesel

Module, Powertrain Control: Removal: Diesel

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the right front tire and wheel assembly.
  4. Remove the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
    Fig 1: Engine Wire Harness Connector At PCM
    GC0158053Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the engine wire harness connector (1).
    Fig 2: Powertrain Control Module (PCM) Wire Harness Connectors
    GC0158192Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the Powertrain Control Module (PCM) wire harness connectors (1).
    Fig 3: Glow Plug Module & Wire Harness Connector
    GC0158082Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the glow plug module wire harness connector (2).
    Fig 4: PCM & Bolts
    GC0158019Courtesy of CHRYSLER GROUP, LLC
  8. Remove the bolts (1) and the PCM (2).
scientia non olet · About LEMON Manuals