LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Electronic Control Modules (Service Information) - 1500) >> Module, Power Sunroof >> Installation >> Installation

Module, Power Sunroof: Installation: Installation

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Do not attempt to move or reposition the sunroof glass panel or drive cables with the sunroof motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.

WARNING:

The sunroof must first be calibrated and the Motor/Module Initialization Procedure must be completed any time a sunroof motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury.

Fig 1: Sunroof Motor/Module, Connector & Screws
GC0083500Courtesy of CHRYSLER GROUP, LLC
  1. Position the power sunroof motor/module (1) in the vehicle.
  2. Install the motor/module retaining screws (3). Tighten the screws to 4 N.m (35 in. lbs.).
  3. Connect the motor/module electrical connector (2).
  4. Partially install the vehicle headliner and connect all remaining sunroof electrical connectors. Refer to HEADLINER, INSTALLATION .
  5. Connect the battery negative cable.
  6. Perform the sunroof position calibration. Refer to MOTOR, SUNROOF, STANDARD PROCEDURE .
  7. Perform the Motor/Module Initialization Procedure. Refer to MOTOR, SUNROOF, STANDARD PROCEDURE .
  8. Complete the vehicle headliner installation. Refer to HEADLINER, INSTALLATION .
  9. Verify proper operation of the power sunroof system.
scientia non olet · About LEMON Manuals