Right Bank

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

No sparks, open flames or smoking. Risk of poisoning from inhaling and swallowing fuel. Risk of injury to eyes and skin from contact with fuel. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing.

NOTE:

Any time a new fuel injector is being installed, or if an existing injector is installed in any location other than its original location, the injector quantity adjustment procedure must be performed. Refer to FUEL INJECTION, DIESEL, STANDARD PROCEDURE .

Fig 1: Fuel Injector Seal

Courtesy of CHRYSLER GROUP, LLC

Remove the protective cap from the appropriate injector bore.
Clean the fuel injectors and injector bore. Refer to INJECTOR(S), FUEL, CLEANING .
Install a new fuel injector seal (1) in the cylinder head cover (2).

Fig 2: Fuel Injector & Sealing Washer
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do Not apply any lubricant to the fuel injector nozzle. Care must be taken not to restrict the discharge orifices in the nozzle.
Install a new sealing washer (2) onto the fuel injector (1).

Fig 3: Fuel Injector, Hold Down Bolt, Washer & Retaining Claw
Courtesy of CHRYSLER GROUP, LLC
Lubricate the fuel injector body with Nickel Anti-Seize Lubricant.
Install the fuel injector (1), tensioning claws (4), washer (3) and bolt (2). Tighten the bolt (2) 33 N.m (24 ft. lbs.).
NOTE:
Fuel tubes are a one time only use and must be replaced anytime they have been removed.
Install the fuel tubes. Refer to TUBE(S), FUEL, INSTALLATION .

Fig 4: Fuel Injector, Return Hose, Retaining Tab & Connector
Courtesy of CHRYSLER GROUP, LLC
Connect the fuel injector harness connector (1).
NOTE:
Do not use any type of lubrication when installing the fuel injector return line.
Install the fuel injector return line (3) and push down on the lock retaining tab (2) to lock in place.
Connect the negative battery cable.
Start the engine and inspect for leaks.

Fig 5: Removing/Installing Intake Manifold Silencer
Courtesy of CHRYSLER GROUP, LLC
Install the fuel injector silencer (1).
Install the intake manifold silencer (1).

Fig 6: Removing/Installing Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover (1).
NOTE:
When ever a fuel injector is replaced.
Using the scan tool, perform Oxygen Sensor Value Reset function found under ENGINE MISCELLANEOUS FUNCTIONS.