Catalyst Exhaust Gas Temperature Sensor
WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- Remove the transmission skid plate. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
- Disconnect the catalyst Exhaust Gas Temperature (EGT) sensor wire harness connector (1).CAUTION:
The exhaust gas temperature sensor requires care when handling and installing. The exhaust gas temperature sensor is sensitive to knocks and bending. For this reason if the exhaust gas temperature sensor has been dropped, it must not be installed as damage to the sensor may have occurred. Do not remove from packaging until ready to install. Failure to follow these instructions may result in damage to the exhaust gas temperature sensor.
- Remove the catalyst EGT sensor (4).