LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 767 (Engine Cooling System - 1500) >> Engine >> Pump, Water >> Removal >> 3.0L

Pump, Water: Removal: 3.0L

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Engine Cover
GC0158138Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect negative battery cable.
  2. Remove the engine cover (1).
  3. Drain the coolant into a clean container. Refer to STANDARD PROCEDURE .
  4. Remove the pressurized coolant bottle. Refer to BOTTLE, PRESSURIZED COOLANT, REMOVAL .
  5. Remove the electric vacuum pump Refer to PUMP, ELECTRIC VACUUM, REMOVAL .
  6. Remove the A/C suction line that is routed in front of water pump to the A/C compressor. Refer to LINE, A/C SUCTION, REMOVAL .
  7. Remove the A/C discharge line that is routed in front of water pump to the A/C compressor. Refer to LINE, A/C DISCHARGE, REMOVAL .
  8. Remove the temperature sensor. Refer to SENSOR, COOLANT TEMPERATURE, REMOVAL .
    Fig 2: Thermostat Housing, Purge Tube, Heater Supply Hose Fitting & Bypass Housing
    GC0146956Courtesy of CHRYSLER GROUP, LLC
  9. Remove the thermostat assembly (1). Refer to THERMOSTAT, REMOVAL .
  10. Remove the coolant recovery bottle purge hose from purge tube (2).
  11. Remove the lower radiator hose at water pump (3) and position aside.
    Fig 3: Belt Tensioner & Bolts
    GC0158176Courtesy of CHRYSLER GROUP, LLC
  12. Remove serpentine belt tensioner assembly. Refer to TENSIONER, BELT, REMOVAL .
    Fig 4: Serpentine Belt Tensioner Bracket & Bolts
    GC0146730Courtesy of CHRYSLER GROUP, LLC
  13. Remove bolts (2, 3) and the belt tensioner mounting bracket (1).
    Fig 5: Fuel Supply Line
    GC0146987Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    The fuel lines are a one time torque. If the fuel lines are removed. They would require replacing.

  14. Remove the fuel supply line (2). Refer to TUBE(S), FUEL, REMOVAL .
    Fig 6: Coolant Tube & Bolts
    GC0158155Courtesy of CHRYSLER GROUP, LLC
  15. Remove bolts (1) and the coolant tube (2).
    Fig 7: Water Pump Assembly, Coolant Inlet Tube, O-Ring & Bolts
    GC0157462Courtesy of CHRYSLER GROUP, LLC
  16. Remove bolts (1) and water pump assembly (2).
  17. Remove bolts (5) and the coolant inlet tube (5).
  18. Remove and discard the O-ring seal (3) from the coolant inlet tube (5).
    Fig 8: Engine Coolant Tube & O-Ring
    GC0157463Courtesy of CHRYSLER GROUP, LLC
  19. Remove and discard O-ring seal (1) from the engine coolant tube (2).
scientia non olet · About LEMON Manuals