LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (3.0L Diesel (Service Information) 1500) >> Engine Block >> Bearing(S), Connecting Rod >> Removal >> Removal

Bearing(S), Connecting Rod: Removal: Removal

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the engine from vehicle. Refer to REMOVAL  .
  3. Remove the oil pump pickup tube. Refer to PICK-UP, OIL PUMP, REMOVAL  .
    Fig 1: Windage Tray & Bolts
    GC0146605Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolts (1) and the windage tray (2).
    Fig 2: Connecting Rod, Bearings & Bolts
    GC0146733Courtesy of CHRYSLER GROUP, LLC
  5. Remove the connecting rod bearing caps one at a time and discard bolts (2).
  6. Carefully remove the upper half and lower bearing half (3) from the connecting rod.
scientia non olet · About LEMON Manuals