Mega Cab
WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Open the center glass approximately 5 cm (2 in.).
- Tumble the rear seat assembly into the full down position.
- Disconnect the electric backlite flexible ribbon connector (1).
- Release the adhesive attaching the cover (4) to the backlite frame and separate the cover (4).
- Slide the upper run channel (1) out of the window frame (2).
- Separate the cable housing block from the lower left glass run channel and disconnect the left side cable from the glass.
- Slide the vent glass (3) upward to remove from the lower window frame.
- Lower the glass (3) out of the upper window frame (2) and remove.
- Disconnect the right side cable and remove the glass.