Diagnostic Test

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

OTHER DTCS
1. Turn the ignition on, engine not running.
2. With the scan tool, read DTCs.
  Are any other injector/fuel pressure related DTCs present?
  
  Yes
  - Diagnose and repair all other injector/fuel pressure related DTCs before performing this diagnostic tree.
  No
  - Go To 2
ACTIVE DTC
1. With the scan tool, record all Freeze frame data.
2. With the scan tool, erase DTCs.
3. Turn the ignition off for 75 seconds.
4. Operate the engine until the coolant temperature is above 82.2°C (180°F).
5. With the scan tool, read DTCs.
  Did DTC P0093 reset?
  
  Yes
  - Go To 3
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION - 6.7L .
EXTERNAL FUEL LEAKS
1. Put on personal protective equipment.
2. Operate engine at idle when looking for fuel leaks.
3. Use the scan tool to operate engine at a variety of engine speeds.
  Any external leaks detected?
  
  Yes
  - Repair or replace component with external fuel leak.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .
  No
  - Go To 4
CHECK THE FUEL DELIVERY SYSTEM
1. Refer to DIAGNOSIS AND TESTING, 6.7L and perform the CHECKING THE FUEL DELIVERY SYSTEM diagnostic procedure.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  No
  - Replace the Powertrain Control Module in accordance with the Service Information. Refer to REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .