LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Anti-Lock Brake System (Abs) (Service Information)) >> Electrical >> SENSOR, Dynamics >> Removal >> Removing Dynamics Sensor

Removing Dynamics Sensor

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the dynamics sensor is replaced, it must be initialized using the scan tool.

Fig 1: Locating Occupant Restraint Controller
GC0094879Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. If equipped with a center floor console, remove the console. Refer to CONSOLE, Floor , Removal .
  3. If equipped with a 40/20/40 bench seat, remove the passenger seat. Refer to SEAT, Front , Removal and SEAT, Front Center , Removal .
  4. Disconnect the electrical connector (4) for the dynamics sensor (2).
  5. Remove the three mounting nuts (1) for the sensor (2).
  6. Remove the sensor (2) from the vehicle.
scientia non olet · About LEMON Manuals