Sensor, TMAP-Intake Manifold: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover, Bolts & Oil Dipstick

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate both negative battery cables.
Remove the engine oil dipstick (2).
Remove bolts (1) and the engine cover (3).

Fig 2: Bulk Head Connector
Courtesy of CHRYSLER GROUP, LLC
Cut the cable tie and position aside the bulk head connector (1).

Fig 3: EGR Bypass Valve Harness Connector & Exhaust Pressure Sensor Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the exhaust pressure sensor wire harness connector (2).
Disconnect the EGR cooler bypass valve wire harness connector (1).

Fig 4: Crankcase Pressure Sensor Wire Harness Connector & Clamp
Courtesy of CHRYSLER GROUP, LLC
Disconnect the crankcase pressure sensor 2 wire harness connector (1).

Fig 5: Identifying Crankcase Pressure Sensor And Components
Courtesy of CHRYSLER GROUP, LLC
Disconnect crankcase pressure sensor 1 wire harness connectors (7).

Fig 6: Injector Harness Connectors
Courtesy of CHRYSLER GROUP, LLC
Disconnect both fuel injector harness connectors (1).

Fig 7: Oil Drain Hose
Courtesy of CHRYSLER GROUP, LLC
Remove the CCV oil drains hoses (2) from cylinder head cover.

Fig 8: Fuel Tube Silencer
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel tube silencer (1).

Fig 9: TMAP Sensor, Wire Harness Connector & Bolt
Courtesy of CHRYSLER GROUP, LLC
Clean the area around TMAP sensor (4).
Disconnect the TMAP sensor wire harness connector (3).
Remove screw (5) and the TMAP sensor (4).