LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 696 (Fuel System - 2500 Hd & 3500 Hd) >> Fuel Injection, 6.7L Diesel >> Heater, Air Intake >> Removal >> Removal

Heater, Air Intake: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Intake Heater Assembly Components
GC0108836Courtesy of CHRYSLER GROUP, LLC
NOTE:

If servicing the heater element (1) is required, the entire air intake heater assembly (2) must be replaced.

Fig 2: EGR Air Flow Control Valve Location
GC0108834Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect both negative battery cables.
  2. Remove the intake manifold (2). Refer to MANIFOLD, INTAKE, REMOVAL, 6.7L .
  3. Remove fuel rail. Refer to RAIL, FUEL, REMOVAL .
    Fig 3: Identifying Intake Heater Cable Connection
    GC0108837Courtesy of CHRYSLER GROUP, LLC
  4. Remove heater cable nut (2) and the heater cable from stud.
  5. Disconnect fuel injector harness connectors (1) and (6).
  6. Disconnect crankcase vent line (3) at top of valve cover.
  7. Disconnect crankcase pressure sensor harness connector (5).
    Fig 4: Air Intake Heater Assembly Components
    GC0108836Courtesy of CHRYSLER GROUP, LLC
  8. Remove bolts (4) and the air intake heater assembly (2).
  9. Remove and discard gasket (5).
scientia non olet · About LEMON Manuals