Tube, Fuel Tank Filler: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Tank Filler Tube

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Disconnect the DEF filler hose at filler neck tube (2).
Disconnect the DEF vent hose at filler neck tube (1).
Partially lower the vehicle.
Remove the left rear wheel house splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .

Fig 2: Remove/Install Tubes
Courtesy of CHRYSLER GROUP, LLC
Loosen clamp (4) and disconnect the diesel fuel filler tube.
Loosen clamp (1) and disconnect the diesel fuel vent tube (2).
Remove nut (5) securing the ground wire (5) to frame rail.

Fig 3: Tank Fitting & Fuel Vapor Hose
Courtesy of CHRYSLER GROUP, LLC
Disconnect the fuel vapor hose (2) from tank fitting (1).

Fig 4: DEF Cap
Courtesy of CHRYSLER GROUP, LLC
Lower the vehicle.
Remove the DEF cap (1).

Fig 5: Fuel Filler Tube Screws
Courtesy of CHRYSLER GROUP, LLC
Remove screws and the fuel filler tube through wheel well.