Sensor, Water In Fuel: Installation: Secondary
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Using a new O-ring (2), install the Water in Fuel (WIF) sensor (3) and securely tighten.
- Connect the WIF sensor harness connector.
- Connect both negative battery cables.
- The engine has a self-priming low-pressure fuel system. To prim the fuel system. Refer to PUMP, FUEL TRANSFER .
- Start engine and check for leaks.