Sensor, Fuel Pressure: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover, Bolts & Oil Dipstick

Courtesy of CHRYSLER GROUP, LLC

Disconnect both negative battery cables.
Remove the oil dipstick (2).
Remove bolts (1) and the engine cover (2).

Fig 2: Bulk Head Connector
Courtesy of CHRYSLER GROUP, LLC
Cut the cable tie and position aside the bulk head connector (1).
If equipped, remove the transmission dipstick (3).

Fig 3: EGR Bypass Valve Harness Connector & Exhaust Pressure Sensor Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the exhaust pressure sensor wire harness connector (2).
Disconnect the EGR cooler bypass valve wire harness connector (1).

Fig 4: Crankcase Pressure Sensor Wire Harness Connector & Clamp
Courtesy of CHRYSLER GROUP, LLC
Disconnect the crankcase pressure sensor 2 wire harness connector (1).

Fig 5: Identifying Crankcase Pressure Sensor And Components
Courtesy of CHRYSLER GROUP, LLC
Disconnect crankcase pressure sensor 1 wire harness connectors (7).

Fig 6: Injector Harness Connectors
Courtesy of CHRYSLER GROUP, LLC
Disconnect both fuel injector harness connectors (1).

Fig 7: Oil Drain Hose
Courtesy of CHRYSLER GROUP, LLC
Remove the CCV oil drains hoses (3) from cylinder head cover.

Fig 8: Fuel Tube Silencer
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel tube silencer (1).

Fig 9: Removing/Installing Fuel Line Shield, High Pressure Fuel Lines, HPC Connector Tube, Fuel Injectors & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove two bolts (4) and No. 6 fuel tube shield (5) at rear of cylinder head.
Remove cylinder No. 5 and No. 6 fuel lines (3 and 6).

Fig 10: Fuel Pressure Sensor & Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the fuel pressure sensor wire harness connector (2).

Fig 11: Remove/Install Fuel Pressure Sensor
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do not use an impact socket, the socket wall is too thick and will not work.
Using a 27 mm thin walled socket (3), remove fuel pressure sensor (2).