Diagnostic Test

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
1. Cycle the ignition on.
2. Using the scan tool, record and erase the DTCs.
3. With the scan tool, select: RF Hub, More Options and System Tests.
4. Perform the RF Hub LF Antenna Verification Tests. Refer to STANDARD PROCEDURE .
5. With the scan tool, read the Active DTCs.
  Does the scan tool display: B1A72-11-PASSIVE ENTRY ANTENNA 2 - CIRCUIT SHORT TO GROUND as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
(D922) PASSIVE ENTRY ANTENNA SHORTED
1. Cycle the ignition off.
2. Disconnect the Passive Entry Antenna 2 connector.
3. Cycle the ignition on.
4. Using the scan tool, record and erase the DTCs.
5. With the scan tool, select: RF Hub, More Options and System Tests.
6. Perform the RF Hub LF Antenna Verification Tests. Refer to STANDARD PROCEDURE .
7. With the scan tool, read the Active DTCs.
  Does the scan tool display: B1A72-11-PASSIVE ENTRY ANTENNA 2 - CIRCUIT SHORT TO GROUND as active?
  
  Yes
  - Go To 3
  No
  - Replace the Antenna in accordance with the service information.
(D922) PASSIVE ENTRY ANTENNA 2 SIGNAL CIRCUIT SHORTED TO GROUND

Fig 1: Measuring Resistance Between Ground & Passive Entry Antenna 2 Signal Circuit
Courtesy of CHRYSLER GROUP, LLC
1. Cycle the ignition off.
2. Disconnect the RF Hub Module C2 harness connector.
3. Measure the resistance between ground and the (D922) Passive Entry Antenna 2 Signal circuit.
  Is the resistance below 30K Ohms?
  
  Yes
  - Repair the short to ground in the (D922) Passive Entry Antenna 2 Signal circuit.
  No
  - Go To 4
(D923) PASSIVE ENTRY ANTENNA 2 RETURN CIRCUIT SHORTED TO GROUND

Fig 2: Measuring Resistance Between Ground & Passive Entry Antenna 2 Return Circuit
Courtesy of CHRYSLER GROUP, LLC
1. Measure the resistance between ground and the (D923) Passive Entry Antenna 2 Return circuit.
  Is the resistance below 30K Ohms?
  
  Yes
  - Repair the short to ground in the (D923) Passive Entry Antenna 2 Return circuit.
  No
  - Replace the RF Hub in accordance with the Service Information. Refer to MODULE, RADIO FREQUENCY (RF HUB), REMOVAL .
  - Perform the RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST. Refer to STANDARD PROCEDURE .