Module, Radio Frequency (RF Hub): Installation: Installation
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
The Remote Frequency Hub Module (RF Hub) assembly consists of a harness connector and two pushpin.
The control module is located behind the rear cab panel beneath the rear sliding glass assembly. The remote start antenna is plugged directly into the RH Hub
- Disconnect and isolate the negative battery cable.
- Position into place and install the RF Hub (1) and retainers (3).
- Connect the electrical connectors to the RF Hub (2).
- If equipped, connect the remote start coax cable electrical connector to the RF hub.
- Install left side rear cab trim panels and install the panel push pins. Refer to PANEL, CAB BACK TRIM, INSTALLATION .
- Install left rear child seat tether. Refer to ANCHOR, CHILD SEAT, INSTALLATION .
- Install left rear seat. Refer to SEAT, REAR, INSTALLATION and SEAT, MEGA CAB REAR, INSTALLATION .
- Install the left rear seat rear inboard bolt with seat belt buckle. Refer to BUCKLE, SEAT BELT, INSTALLATION .
- Flip the left rear seat cushion down.
- Connect the negative battery terminal to the negative battery post.
- Perform RF Hub replacement procedure with the scan tool. Refer to STANDARD PROCEDURE .