Module, Integrated Trailer Brake (ITBM): Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Column Opening Cover & Fasteners

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the battery negative cable.
Remove the steering column opening cover retaining screws (2).
Using a trim stick, remove the steering column opening cover (1) from the instrument panel and position aside.

Fig 2: Instrument Panel Side Cover
Courtesy of CHRYSLER GROUP, LLC
Using a trim stick, from the notch on the bottom, remove the left instrument panel side cover (1).

Fig 3: Installing Integrated Trailer Brake Module (ITBM) Electrical Connectors
Courtesy of CHRYSLER GROUP, LLC
From under the instrument panel, disconnect the integrated trailer brake module (ITBM) electrical connectors (1).
NOTE:
One screw on the right front of the ITBM not shown.
Remove the three ITBM retainer screws (1).
NOTE:
There is a retainer clip on each side of the ITBM near the bottom.
Using a trim stick, remove the ITBM (1) from the IP.