LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Electronic Control Modules (Service Information) 2500 Hd & 3500 Hd) >> Module, Final Drive Control >> Removal >> Removal

Module, Final Drive Control: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Stabilizer Bar Actuator
GC0107515Courtesy of CHRYSLER GROUP, LLC
WARNING:

The disconnecting stabilizer bar unit (3) is not serviced separately from the bar (4). Do not disassemble this unit from the stabilizer bar.

NOTE:

The Final Drive Control Module (FDCM) is integrated with the front stabilizer actuator.

  1. Raise and support the vehicle.
    NOTE:

    Before removing the connector from the actuator (1) clean the outside of the connector with a cleaner and compressed air, to remove any dirt or debris.

  2. Disconnect the electronic actuator electrical connector for the disconnecting stabilizer bar.
  3. Remove the 3 actuator bolts (2) then remove the actuator (1).
scientia non olet · About LEMON Manuals