Section 658 (Charging (Service Information) 2500 Hd & 3500 Hd): Generator: Removal: 5.7L
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Disconnect the negative cable from the battery before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage to the electrical system.
- Disconnect the negative battery cable.
- Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
- Unsnap the plastic insulator cap from the B+ output terminal.
- Remove the B+ terminal mounting nut at the rear of the generator (1). Disconnect the terminal from the generator.
- Disconnect the field wire connector at the rear of generator by pushing on the connector tab.
- Remove the two generator mounting bolts (2).
- Remove the generator from the vehicle.