LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 656 (6.7L Engine (Service Information) 2500 Hd & 3500 Hd) >> Engine Block >> Seal, Crankshaft Oil, Rear >> Removal >> Removal

Seal, Crankshaft Oil, Rear: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Crankshaft Rear Seal Removal
GC0108571Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cables.
  2. On automatic transmission vehicles, remove the flexplate. Refer to FLEXPLATE, REMOVAL, 6.7L .
  3. On Manual transmission vehicles, remove the flywheel. Refer to FLYWHEEL, REMOVAL .
  4. Using a 3/32 (0.0938 in.) drill bit, drill two pilot holes 180° apart into the rear seal (2). Use caution not to contact the crankshaft (3) or the seal retainer when drilling pilot holes.
  5. Install a No. 10 sheet metal screws (1) in the drilled pilot holes and remove the rear seal with a slide hammer (4).
scientia non olet · About LEMON Manuals