LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 656 (6.7L Engine (Service Information) 2500 Hd & 3500 Hd) >> Cylinder Head >> Valves, Intake And Exhaust >> Removal >> Removal

Valves, Intake And Exhaust: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Spring Compressor Mounting Base-Part Of Tool 8319
GC0108518Courtesy of CHRYSLER GROUP, LLC
  1. Remove the cylinder head. Refer to CYLINDER HEAD, REMOVAL, 6.7L .
  2. Support cylinder head on stands.
  3. Install the valve spring compressor base 8313A (1) as shown in illustration.
    Fig 2: Compressing Valve Springs With Tool 8319
    GC0108519Courtesy of CHRYSLER GROUP, LLC
  4. Install the valve spring compressor (special tool #8319, Compressor, Valve Spring) top plate, washer, and nut. Using a suitable wrench, tighten the nut (clockwise) to compress the valve springs and remove the locks.
  5. Rotate the compressor nut counter-clockwise to relieve tension on the springs. Remove the spring compressor (1).
    Fig 3: Valve Assembly Configuration
    GC0108520Courtesy of CHRYSLER GROUP, LLC
  6. Remove the retainers (5), springs (4), valve seals (3) (if necessary), and valves (2). Arrange or number all components so they can be installed in their original locations.
  7. Repeat the procedure on all cylinders to be serviced.
scientia non olet · About LEMON Manuals