Link, Stabilizer Bar: Installation: Installation
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Position the stabilizer link (3) and install the link upper bolt (1) and nut. Do not tighten.
- Install the stabilizer link lower nut (2). Do not tighten.
- Remove the holding fixture supporting the axle.
- Remove the support and lower the vehicle.
- Tighten stabilizer link lower nuts (1, 2) to specifications. Refer to SPECIFICATIONS .