LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 634 (Steering System - 2500 Hd & 3500 Hd) >> Linkage, Link And Coil >> Drag Link, Steering, Link And Coil >> Installation >> To Pitman Arm

To Pitman Arm

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Verify that equal number of thread engagement exists on both ends of adjuster sleeve and that the adjuster sleeve clamps cover the threaded ends.

NOTE:

Prior to installing tapered end suspension components, clean male and female surfaces with brake clean.

Fig 1: Drag Link, Steering, Link And Coil
GC0161598Courtesy of CHRYSLER GROUP, LLC
  1. Install the drag link end (5) to the adjustment sleeve (4) and to the pitman arm.
  2. Install the drag link to pitman arm nut (7) and tighten to specifications. Refer to LINKAGE, LINK AND COIL, SPECIFICATIONS .
  3. Remove the supports and lower the vehicle. Center the steering wheel and adjust the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
  4. After adjustment, tighten the tie rod adjustment sleeve jam nuts to specifications. Refer to LINKAGE, LINK AND COIL, SPECIFICATIONS .
scientia non olet · About LEMON Manuals