Gear, Link And Coil: Installation: Installation

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All views are typical.

Fig 1: Identifying Steering Gear And Bolts

Courtesy of CHRYSLER GROUP, LLC

Position the steering gear (1) on the frame rail. Install the three mounting bolts (2), and tighten to specifications (Refer to SPECIFICATIONS ).

Fig 2: Column Shaft
Courtesy of CHRYSLER GROUP, LLC

1 - STEERING COUPLER

2 - STEERING GEAR INPUT SHAFT

Align steering coupler (1) on gear shaft (2). Install pinch bolt and tighten to specifications. Refer to COLUMN, SPECIFICATIONS .

Fig 3: Pitman Arm Installed

Courtesy of CHRYSLER GROUP, LLC

1 - DRAGLINK

2 - STEERING GEAR

3 - SWAYBAR

4 - NUT/WASHER

5 - PITMAN ARM

Align and install the pitman arm (5). Refer to ARM, PITMAN, LINK AND COIL, INSTALLATION .
Install the washer and retaining nut (4) on the pitman shaft. Tighten the nut to specifications (Refer to SPECIFICATIONS ).
Connect fluid hoses to steering gear and tighten to specifications (Refer to SPECIFICATIONS ).
Add fluid. Refer to PUMP, STANDARD PROCEDURE .
Reset the toe and center the steering wheel. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .