Shroud, Steering Column: Installation: Lower

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Column Shroud

Courtesy of CHRYSLER GROUP, LLC

Position the lower shroud (4) over the steering column tilt lever and align on the steering column.
NOTE:
If the vehicle is equipped with an automatic transmission, be certain to engage the gearshift lever boot into the opening in both shroud halves.
Position the upper shroud (1) onto the steering column over the lower shroud (4).
Align the snap features on the upper and lower shroud halves (1, 4) and apply hand pressure to snap together.
From below the steering column, install the two outboard screws within the recess areas (2) that secure the upper shroud (1) to the lower shroud (4).

Fig 2: Steering Column Lower Shroud
Courtesy of CHRYSLER GROUP, LLC
Install the lower shroud to column retaining screw (3).
Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .