Standard Stabilizer Bar
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Position the stabilizer bar on the frame rail and install the clamps and bolts. Ensure the bar is centered with equal spacing on both sides.
- Tighten the clamp bolts to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
- Install links retainers, grommets and nuts (1) to the stabilizer bar. Hold the link shaft with a wrench and tighten the nuts to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
- Remove the supports and lower the vehicle.