Front, Link And Coil: Specifications: Specifications
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Suspension components with rubber/urethane bushings should be tightened with the vehicle at normal ride height. It is important to have the springs supporting the weight of the vehicle when the fasteners are torqued. If springs are not at their normal ride position, vehicle ride comfort could be affected and premature bushing wear may occur.
SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Shock Absorber Upper Nut | 36 | 27 | - |
| Shock Absorber Lower Bolt | 120 | 89 | - |
| Lower Ball Joint Nut Initial Torque | 47 | 35 | - |
| Lower Ball Joint Nut Final Torque | 200 | 148 | - |
| Upper Ball Joint Nut | 94 | 70 | - |
| Control Arm to Frame Nuts | 180 Plus 90° | 133 Plus 90° | - |
| Control Arm to Axle Nut | 180 Plus 90° | 133 Plus 90° | - |
| Stabilizer Bar Frame Bolt | 58 | 43 | - |
| Stabilizer Link Axle Bracket | 149 | 110 | - |
| Stabilizer Link Stabilizer Bar Nut | 82 | 60 | - |
| Hub/Bearing Bolts | 202 | 149 | - |
| Axle Nut | 179 Beginning Torque, Then Rotate 5 to 10 Times With a Final Torque of 356 | 132 Beginning Torque, Then Rotate 5 to 10 Times With a Final Torque of 263 | - |
| Track Bar to Frame | 439 | 324 | |
| Track Bar to Axle | 387 | 285 | |
| Tie Rod End Nut | 60 Plus 105° | 44 Plus 105° | - |