LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 621 (Powertrain Control Module (Pcm) - Electrical Diagnostics - 65RFE Automatic Transmission - 1500) >> Diagnosis And Testing >> P0602-Control Module Programming Error/Not Programmed >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

CONTROL MODULE PROGRAMMING ERROR 

NOTE:

Controller is programmed with generic software and will not allow the correct vehicle Powertrain management.

  1. With the scan tool, record the vehicles controller part number.
  2. Select Use Controller Part Number under the Flash Tab.
  3. Flash the controller with the correct software. Refer to MODULE, POWERTRAIN CONTROL, STANDARD PROCEDURE .

    Verify the controller flashed successfully.

    Test Complete 

scientia non olet · About LEMON Manuals