Diagnostic Test
WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- ACTIVE DTC NOTE:
Diagnose any Communication DTCs before continuing.
- Ignition on
- With the scan tool, select View DTCs.NOTE:
It may be necessary to drive the vehicle to meet the conditions to set this DTC, try to repeat the conditions in which the fault originally set by reviewing the Freeze Frame data.
Is the DTC Active or Pending at this time?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE . .
- INTELLIGENT BATTERY SENSOR CIRCUIT DTCS SET IN THE BODY CONTROL MODULE
Are any Intelligent Battery Sensor Circuit DTCs set in the Body Control module?
Yes
- Diagnose the appropriate Intelligent Battery Sensor Circuit DTC in the Body Control module. Refer to BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX - 1500 .
No
- Go To 3
- VERIFY CORRECT BATTERY INSTALLED
- Verify that the correct battery is installed in the vehicle.
Is the correct battery installed?
Yes
- Replace the Intelligent Battery Sensor (IBS) in accordance with the Service Information. Refer to SENSOR, INTELLIGENT BATTERY (IBS), REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE . .
No
- Replace the Battery. Refer to BATTERY, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE . .
- Verify that the correct battery is installed in the vehicle.