LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 617 (5.7L - DTCS P058A To P152A - 1500) >> Diagnosis And Testing >> P06E9-Engine Starter Performance >> When Monitored

When Monitored

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Any time an engine crank command is given.

Set Conditions: 

Immediately after reaching the "start" state, a timer begins to check the overall start time. If the Powertrain Control Module (PCM) does not see the engine speed increase to over 750 RPM within five seconds after the start command is given, a fault is set. One trip fault. If the vehicle is equipped with the stop/start feature, the system will be disabled when this DTC is active. 

scientia non olet · About LEMON Manuals