LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (NV271 Transfer Case (Service Information)) >> LEVER, Transfer Case >> Removal >> Removal

LEVER, Transfer Case: Removal: Removal

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Transfer Case Shifter
GC0109815Courtesy of CHRYSLER LLC
1 - SHIFTER BOOT 4 - SHIFTER MECHANISM
2 - SHIFTER KNOB 5 - ALIGNMENT PIN
3 - SHIFTER CONSOLE 6 - TRANSFER CASE
  1. Shift transfer case into 2H.
  2. Raise and support the vehicle.
  3. Loosen adjusting trunnion lock bolt and slide shift rod out of trunnion. If rod lacks enough travel to come out of trunnion, push trunnion out of shift lever.
  4. Lower vehicle.
  5. Remove transfer case shifter knob cap.
  6. Remove nut holding shifter knob (2) to shift lever. Refer to Fig 1.
  7. Remove shifter knob.
  8. Remove the shift boot from the shifter console.
  9. Remove the bolts securing the shifter mechanism to the floor pan.
  10. Separate shift lever mechanism from the vehicle.
scientia non olet · About LEMON Manuals