LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 569 (Ignition System (Service Information) 1500) >> Sensor, Camshaft Position >> Removal >> Removal

Sensor, Camshaft Position: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Camshaft Position Sensor, Connector & Bolt
GC0146584Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Disconnect Camshaft Position (CMP) sensor harness connector (3).
  3. Remove bolt (1) and the CMP sensor (2).
scientia non olet · About LEMON Manuals