Section 565 (Starting (Service Information) 1500): Starter: Removal: 3.6L
WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Raise the vehicle.
- Remove the starter heat shield (1).
- Remove the battery positive cable connector eyelet (2) from the solenoid battery terminal stud.
- Disconnect the starter relay solenoid electrical connector (1) from the solenoid terminal connector receptacle.
- Remove the two starter bolts (4).
- Move the starter (3) motor towards the front of vehicle far enough for the nose of the starter pinion housing to clear the housing.
- Remove the starter motor.