LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 563 (8HP45/845RE Automatic Transmission (Service Information) 1500) >> Seal, Output Shaft >> Installation >> All Wheel Drive

All Wheel Drive

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

The seal must be installed flush with the case. Driving the seal deeper could damage the seal causing a leak.

  1. Position the new output shaft seal over the output shaft and against the transmission case.
  2. Using (special tool #8481, Installer, Gear) install the output shaft seal.
  3. Install the transfer case. For BW44-44, refer to REMOVAL . For BW44-45, refer to REMOVAL .
  4. Perform the CHECK OIL LEVEL procedure. Refer to FLUID AND FILTER, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals