Pump, Transmission Oil: Assembly: Assembly

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Oil Pump O-Ring

Courtesy of CHRYSLER GROUP, LLC

Install the oil pump seal (2).

Fig 2: Oil Pump Housing & O-Ring
Courtesy of CHRYSLER GROUP, LLC
Install the oil pump O-ring (2).
Carefully seat the oil pump into the housing, make sure the pump is seated properly.

Fig 3: Two Halves Of Oil Pump
Courtesy of CHRYSLER GROUP, LLC
Install the two oil pump housing halves together.

Fig 4: Oil Pump Torx® Bolts
Courtesy of CHRYSLER GROUP, LLC
Install six
NEW

oil pump housing Torx® bolts (1).
Tighten the bolts to 5 N.m (44 in. lbs). plus 45°.

Fig 5: Inner & Outer Oil Pump O-Rings
Courtesy of CHRYSLER GROUP, LLC
Replace the inner and outer oil pump housing O-rings (1).

Fig 6: A-Piston & Seal
Courtesy of CHRYSLER GROUP, LLC
Replace the A- piston seal (2) and install the A-piston (1).

Fig 7: Piston Retaining Ring And Piston
Courtesy of CHRYSLER GROUP, LLC
Install the Belleville spring (1).

Fig 8: Oil Pump Housing Assembly
Courtesy of CHRYSLER GROUP, LLC
Position the oil pump housing assembly (4) in a suitable arbor press.
Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the piston retaining ring to remove tension, and install the two halves of the split retainer ring (2).

Fig 9: Outer Ring, Snap Ring, Hub & Spacers
Courtesy of CHRYSLER GROUP, LLC
Install the hub (3).
Install the clutches and spacers (4).
Install the snap ring (2).
Install the outer ring (1) (below B-piston).

Fig 10: B-Piston Alignment Tab & B-Piston
Courtesy of CHRYSLER GROUP, LLC
Position the B-piston alignment tab (2) above the notch and install B-piston (1) on the assembly.