SENSOR, Oxygen: Operation: Operation
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
PICK UP MODELS
A separate O2 Sensor Module (1) is also used.
The engine aftertreatment system monitors the O2 content in the diesel engine exhaust. The Powertrain Control Module (PCM) monitors the exhaust gases for oxygen content and varies the rich/lean fuel mixture of the intake air fuel mixture to adjust the system. This diagnostic monitors the status message broadcast by the O2 Sensor Module (1) for the upstream O2 sensor™ internal heater circuit. The PCM will set the fault if it receives a FMI (Failure Mode Indicator) message from the O2 Sensor Module. The PCM will illuminate the MIL lamp immediately when the diagnostic runs and fails. The PCM will turn off the MIL lamp diagnostic runs and passes in four consecutive drive cycles.