Lifter(S), Hydraulic: Installation: Installation
WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The LH cylinder head hydraulic lifters are shown in illustration, the RH cylinder head hydraulic lifters are similar. If the hydraulic lifters are being reused, reassemble them into their original locations.
- Verify that the hydraulic lifters are at least partially full of oil. There should be little or no plunger travel when the hydraulic lifter is depressed.
- Install the hydraulic lifter(s) (1).NOTE:
If the rocker arms are being reused, reassemble them into their original locations.
- Install the rocker arm(s). Refer to ROCKER ARM, VALVE, INSTALLATION .
- Install the camshaft(s), phasers, cylinder head cover(s) and upper intake manifold. Refer to CAMSHAFT, ENGINE, INSTALLATION .
- Connect the negative battery cable and tighten nut to the proper specification. Refer to SPECIFICATIONS .